Bunny-san
member
Posts: 91
Loc: Allen
Reg: 06-30-07
|
05-09-10 03:00 PM - Post#110695
Where can I buy 22 gauge brass sheet metal? I don't need much...maybe a piece about 8"x10"?
|
vm7mm
enthusiast
Posts: 1381
Loc: Allen Tx usa
Reg: 08-12-04
|
05-09-10 04:57 PM - Post#110696
In response to Bunny-san
Maybe Hobby Lobby?
|
denisew
Community Expert
Posts: 8757
Loc: Allen, TX
Reg: 02-18-02
|
05-10-10 08:05 AM - Post#110706
In response to vm7mm
I don't know about brass, but have seen sheet metal at Home Depot and Lowes.
|
civicminded
Community Guide
Posts: 9247
Loc: Lone Star State
Reg: 04-24-02
|
05-10-10 08:26 AM - Post#110708
In response to Bunny-san
Good suggestions so far, but ask perhaps some AC companies or the local recyclers (metal salvage sites), as they may know where to find it?
|
Michael
enthusiast
Posts: 1982
Loc: Allen
Reg: 05-20-02
|
05-10-10 03:39 PM - Post#110740
In response to Bunny-san
You might try McMaster-Carr. I think they sell to the general public. Shipping cost may make it not a deal though.
McMaster-Carr
| I don't suffer from insanity. I enjoy every minute of it! |
|
Bunny-san
member
Posts: 91
Loc: Allen
Reg: 06-30-07
|
05-10-10 05:13 PM - Post#110752
In response to Michael
Thanks, everyone!
|
rclark
enthusiast
Posts: 800
Loc: Allen, TX
Reg: 01-16-08
|
05-10-10 10:46 PM - Post#110789
In response to Bunny-san
There was a small model shop on the Northeast corner of Parker and Hwy. 5 in Plano. I haven't been inside it for a couple years. I guess they are still there? Also, Hobbytown USA in Plano, if they are still there. They had lots of metal sheet and rod stock.
Two plus two equals five, for sufficiently large values of two.
|
|
